Our Products
UV water purification system
UV water purification system with UV sterilization, It features built-in temperature control and an integrated LCD display. It can produce various kinds of water quality through your combination. This system was designed for the application in the civil, industrial and agricultural field of application in order to promote the de-structuring and the mineralization of pollutants (pesticides, drugs and detergents) in wastewater. It uses UV power lamps (4 in this device) in a 80 liters tank. In the 3D sketch you can see the water inlet (top) and outlet port (bottom).
Thermo-desorber unit for on-line aerosol particles conditioning
This is a Thermo-desorber unit for online aerosol particle conditioning. It can be used for conditioning the product with heat desorption vaporization, the gas of inorganic particles to the non-combustible gas, and residual particles by the benign principle and means that the use of power is low cost.
Thermo-desorber unit for aerosol particles collected on a roll quartz fiber filter
The Thermo-desorber is a unit for aerosol particles collected on a roll quartz fiber filter. This unit is designed to remove moisture from aerosols collected by microfiltration or airification techniques.
Simulation Chamber for aerosol/gas experiments
The simulation chamber for aerosol/gas experiments is able to simulate the environment of chambers such as the chamber used in chemical experiments.
Low Volume Isokinetic Flow Splitter (1 m3/h) for aerosol particles Inlet sampling
This device allows isokinetic air sampling at a low flow rate (1 m3/h) to use in conjunction with standard EPA sampling inlet head (PM10, PM2,5, or PM1). Inlet pipe diameter is 1” (or less). Outlet ports are 1/4”, 3/8”, and 1/2” tubes depending on the instrument flow rate (max 6 instruments/ports). RH/T internal probe is possible. With an internal flow laminator.
High Volume Isokinetic Flow Splitter (30 m3/h) for aerosol particles Inlet sampling
This device allows isokinetic air sampling at a high flow rate (up to 30 m3/h) for long inlet piping (up to 20 meters) and multiple aerosol/gas instrumentation (3,6,9,12). Outlet ports are 1/4”, 3/8”, and 1/2” tubes depending on instrument flow rate. Inlet diameter Inox tube is 100 mm approx. RH/T internal probe is possible. With internal flow laminator.
Cold Plasma torch for air/gas de-pollution
The Cold Plasma Torch is designed for the removal of contaminant gases/atmospheres from compressed air and gas streams. The plasma is generated by applying a low-voltage direct electrical energy source to an arc-shaped electrode pair. The molten glass that results from the explosion of Hydrogen isotopes at 4500º C creates an extremely negative electric field that attracts gaseous matter towards itself, thereby separating it from its original medium. This creates cold plasma in the form of tiny droplets (approximately 1.5 microns) that can be captured as a gas or compressed air by any suitable receptacle, such as an evacuated container, so long as sufficient vacuuming can be obtained through the use of high static pressure.
2D motorized frame
The device is used for moving a probe in a 2D plan for precise positioning (eg., light source, vibration/ noise sensor..). This version has a manual remote control without a software interface. WiFi is possible.